Caravan number plate

johndailey
johndailey Forum Participant Posts: 520
100 Comments
edited December 2018 in Caravans #1

I have just changed cars and need to affix a new stick on number plate to the caravan. Is it necessary to remove the old plate or will sticking (with double sided pads) the new one on to the old one suffice? Many thanks in anticipation and a merry Christmas to you all.

Comments

  • EmilysDad
    EmilysDad Forum Participant Posts: 8,973
    1000 Comments
    edited December 2018 #2

    I suppose you could stick it on the old plate but removing your old plate isn't difficult. If you bought a 3rd car while owning this caravan, would you stick a 3rd plate on top of the other two? 😉 

  • johndailey
    johndailey Forum Participant Posts: 520
    100 Comments
    edited December 2018 #3

    A fair point MM. I Think I wont be so lazy and remove the previous plate!

  • EmilysDad
    EmilysDad Forum Participant Posts: 8,973
    1000 Comments
    edited December 2018 #4

     They say dental floss makes a good cheese cutter .... 😉 though I've just pulled them off from one end. 

  • Tinwheeler
    Tinwheeler Forum Participant Posts: 23,148 ✭✭✭
    10,000 Likes 1000 Comments Name Dropper
    edited December 2018 #5

    I’ve heard of warming with a hair dryer to soften the glue.

  • ocsid
    ocsid Forum Participant Posts: 1,395
    1000 Comments
    edited December 2018 #6

    I have a "cheese-wire" I made years ago using that brass muti strand wire sold for wall hanging pictures, with two handles of sticks cut from pruning an apple tree. The wire is sold in a little envelope in appropriate DIY stores, and of course any round 1 > 1.5 cm diameter sticks or dowel would suit.

  • Oneputt
    Oneputt Club Member Posts: 9,145 ✭✭✭
    2,500 Likes 1000 Comments
    edited December 2018 #7

    Some years ago I brought a frame for the van where I can use different vehicles to tow just by opening the frame and replacing the number plate.

  • allanandjean
    allanandjean Club Member Posts: 2,401 ✭✭✭✭
    1000 Comments
    edited December 2018 #8

    The van we have kept longest was a Hobby and this was towed by several different cars, ours and my employers, and had a frame which the number plate clipped into making it a simple easy job to change over when required.

    I would try the heating first, if that is practicable, or the slow peel.

  • EasyT
    EasyT Forum Participant Posts: 16,194
    1000 Comments
    edited December 2018 #9

    I have used monofilament fishing line to help neighbour remove his plate a few years back. Doesn't scratch the van

  • hitchglitch
    hitchglitch Forum Participant Posts: 3,007
    1000 Comments
    edited December 2018 #10

    I used double sided tape to fix a new number plate - the plate fell off. Make sure you get a good quality tape.

  • johndailey
    johndailey Forum Participant Posts: 520
    100 Comments
    edited December 2018 #11

    Thank you everybody. Some good ideas there.

  • EmilysDad
    EmilysDad Forum Participant Posts: 8,973
    1000 Comments
    edited December 2018 #12

    There's double sided tape and there are double sided sticky pads especially for the job Halfords or ..... I just used half a packet of sticky pads from WHS to fix mine & it's still there. 

  • Nuggy
    Nuggy Forum Participant Posts: 512
    edited December 2018 #13

    I used 5 double sided pads supplied by the "number plate shop" and some time later on a hot sunny day I found the plate on the floor. It is now screwed on tight.  

  • EmilysDad
    EmilysDad Forum Participant Posts: 8,973
    1000 Comments
    edited December 2018 #14

    Just unlucky, cr4ppy sticky pads or you didn't clean either or both faces up properly. I've stuck number plates to various cars & caravans, even curved faces, with no problems, even in last summer's very hot weather. 😉

Categories