New to towing a caravan

fikemp
fikemp Forum Participant Posts: 2
edited September 2016 in Introductions #1

HI there, just bought our first van at the ripe young age of 51, looking forward to it after a horrible camping trip with wind and rain this (so called) summer.

Its a 2006 Bailey Pageant series 5 Burgundy and is a lovely van. HOWEVER, i have a problem already. My break lights wont stay on. I hook up the van and the side lights work, indicators work, fog light works, but the brake lights will come on for a second,
and then go out, leaving just the side lights. If i do this a few times the same happens, but after 4 or 5 times, it then just doesnt light up at all.

Any help would be greatly appreicated, and apologies if this is not in the right location on the site, but looking for advice on what the problem could be. I have looked at the plug and all appears to be in order.

Regards

Graham and Fiona

Comments

  • johndailey
    johndailey Forum Participant Posts: 520
    100 Comments
    edited September 2016 #2

    Hi there. I am no electrician but plenty of people on this forum are quite knowledgable on the subject and hopefully will be on here soon to give advice. No doubt they may ask if you have the 16 pin plug from your car to caravan. be prepaired to submit information
    to aid them. Sorry that I can't help. Bet it is not a big snag. Good luck.

  • EmilysDad
    EmilysDad Forum Participant Posts: 8,973
    1000 Comments
    edited September 2016 #3

    how many brake lights are fitted to the caravan, just the two or maybe there are another 2 at the top? Undecided Just thinking that there
    might be too much load on your towcar's brake light system ..... assuming all is wired up correctly. Does your car & caravan have a 12S & 12N plug/socket or a 13 pin plug/socket?

  • johndailey
    johndailey Forum Participant Posts: 520
    100 Comments
    edited September 2016 #4

    Sorry, meant 13 plug socket as MM has asked.

  • EmilysDad
    EmilysDad Forum Participant Posts: 8,973
    1000 Comments
    edited September 2016 #5

    Sorry, meant 13 plug socket as MM has asked.

    We knew what you meant Wink

  • semedler
    semedler Forum Participant Posts: 21
    edited September 2016 #6

    Your local towbar fitter will have a test system he can plug into the car socket and should only take a few mins to try so then you'll know if the fault is with car or van. 

  • Wildwood
    Wildwood Club Member Posts: 3,581 ✭✭✭✭
    1000 Comments Photogenic
    edited September 2016 #7

    If the car is wired correctly then I would suggest the caravan light sockets are corroded. You need to remove the bulbs and clean up the sockets and see if that cures it. Not sure how long the caravan had been stood before you bought it but if for some time
    that could explain it.

  • Malcolm Mehta
    Malcolm Mehta Forum Participant Posts: 5,660
    1000 Comments
    edited September 2016 #8

    Welcome to Club Together, Graham and Fiona.I've had that problem too. If you are a member of a breakdown service, you can call them out. Mayday's Green Flag can usually fix the problem.

  • fikemp
    fikemp Forum Participant Posts: 2
    edited September 2016 #9

    All,

    Thanks for the advice and help. I think i have found out the problem, My truck is a 2016 ford ranger, with a 16 pin socket on the tow bar, and the brake lights on the clycle rack work fin. When i connected to the caravan, the brake lights would come on for
    a brief second and then go off again. There are 4 brake lights on the back of the van, so as mentioned, its pulling more power than the truck can offer. I have dissconnnected the top 2 bulbs, and the brake lights at the bottom work fine just now. I have been
    advised to get LED bulbs for the top lights and this will solve the problem. I will let you all know if this is the case but thanks for all the advice.

  • Tirril
    Tirril Forum Participant Posts: 439
    100 Comments
    edited September 2016 #10

    I am sure the led bulbs will work fine as there have been a number of posts on CT with the reverse problem. This was that LEDs  having a lighter load were actually fooling the tow car into thinking the bulbs were not working due to their low demand.

  • EmilysDad
    EmilysDad Forum Participant Posts: 8,973
    1000 Comments
    edited September 2016 #11

     ..... There are 4 brake lights on the back of the van, so as mentioned, its pulling more power than the truck can offer.  ....

    I was right ..... do I get a prize? Cool

  • necshowl
    necshowl Forum Participant Posts: 1
    edited September 2016 #12

    Good article

  • JillwithaJay
    JillwithaJay Club Member Posts: 2,485 ✭✭
    500 Likes 1000 Comments
    edited September 2016 #13

    Test.

    photo 78301b06-7bdd-45fe-8ae2-d4d2cae14135_zpssi5htrez.jpg

  • Malcolm Mehta
    Malcolm Mehta Forum Participant Posts: 5,660
    1000 Comments
    edited September 2016 #14

    We had our 13 pin plug replaced for a new one. Now it works fine.

  • DSB
    DSB Club Member Posts: 5,666 ✭✭✭
    1,000 Likes 1000 Comments Name Dropper Photogenic
    edited October 2016 #15

    Welcome to Club Together fikemp.  Hope you manged to get the lights working OK.  Look forward to reading your future posts.

    David