Purple Line KoJack (Jack & Level)

catherinef
catherinef Forum Participant Posts: 647
edited February 2017 in Parts & Accessories #1

Have an CC members got one of these?

I've heard predominantly positive comments about them, but at the same time I've seen negatives too.

 I know there are alternatives such as the Alko Jack, Lock N Level and Trolley Jacks but for the purpose of this thread it's just the KoJack I'd like to hear about.

Comments

  • MeatHome
    MeatHome Forum Participant Posts: 54
    edited February 2017 #2

    Have recently purchased jack and fitted the jacking points

    Fortunately not had to use it yet except to test

    Be aware however that older stock of single axle Kojack is supplied with large jacking point which would not fit my van because mud flap meant there was not clearance

    Eventually ascertained that new stock came supplied with smaller jacking point, and when I eventually found a supplier who had these in stock fitting was no problem 

  • catherinef
    catherinef Forum Participant Posts: 647
    edited February 2017 #3

    Were you happy when you tested it?

  • dmiller555
    dmiller555 Forum Participant Posts: 717
    500 Comments
    edited February 2017 #4

    Draper sell a 2 tonne bottle jack ref 39054 

    Don't know anything about them except that they are cheap, about £20

  • Richard M
    Richard M Forum Participant Posts: 41
    edited February 2017 #5

    I fitted one to mu Sprite Alpine a couple of years ago, it was my choice due the robust build of the chassis brackets, Never used it with a flat bu have used it to remove the wheels. A far better solution when compared to the Alko fittings stronger and more positive location for safety

     

  • MeatHome
    MeatHome Forum Participant Posts: 54
    edited February 2017 #6

    Yes happy when tested 

    No problems 

  • Brian1
    Brian1 Forum Participant Posts: 242
    100 Comments
    edited February 2017 #7

    The USP of the Kojack is that the bottle jack comes with special brackets that you can bolt on to the chasis, so that the jack locks in to them securely and is in no danger of slipping.  The jack itself is an ordinary bottle jack.

     

    I had one and found it very good. (The levelling bit is a gimmick though, no use at all to me).

  • catherinef
    catherinef Forum Participant Posts: 647
    edited February 2017 #8

    Thanks all, this is really very helpful.  To be honest I'm only interested in it for the fitting of Alko locks.  

    Tempted to take the plunge on one as it seems to be the sensible middle ground option between trolley jack and locknlevel.

  • Brian1
    Brian1 Forum Participant Posts: 242
    100 Comments
    edited February 2017 #9

    To rotate the wheel to fit an ALko lock you will need the brakes off.  Even if jacked up and the other side wedged this could be dangerous IMO.

    If you have a mover fitted, fitting an ALko lock is straightforward.  If not, I'd suggest getting a different make of wheel lock that is less hassle.

  • catherinef
    catherinef Forum Participant Posts: 647
    edited February 2017 #10

    We find fitting an Alko easy on the current single axlre van, but as we are about to take delivery of a twin axle which is going to be a completely different situation.