Autocruise step
Has anyone experienced a problem after changing their engine battery on a Autocruise Starlet 2 , everything worked fine until the battery change and now the step will not operate without a mains connection and I have no engine voltage showing on the
control panel, although the engine turns over and starts . I have seen a similar fault mentioned back in March from a club member after a battery change , has anyone else had a similar problem and found a remedy
Comments
-
Probably a similar sort of issue with car radios not working if the battery is disconnected. A fairly simple cure, I would imagine. Have you checked the handbook/googled the problem?
0 -
Thats already been covered under " C/van & M/home Chat "
.0 -
Thanks everyone for you help and ideas in sorting this fault , I have a few things to check now , so out with the toolbox asap and check those fuses
0 -
IF" i new how to ,,,,i would !!. E.T .0
-
Simple .. Navigate to post you want to refer to and copy the title from the top line of your browser .. Then insert it in your post ..
Simple ..
0 -
Thanks 'Q' .0
