Water inlet housing / pump

John and Patricia
John and Patricia Forum Participant Posts: 5
edited July 2021 in Caravans #1

Hi all 

Hope you can help my cover of my water pump inlet housing has snapped and the whole housing 

looks shabby so I am wanting to order a new one and as my pump is also very old and has a leak I'm planning on replacing

that at the same time. 

So question is which unit do I order?

My van is a Bailey Discovery 516 2002 

I have attached a few photo's to help identify  

Can you help please

Comments

  • JVB66
    JVB66 Forum Participant Posts: 22,892
    1000 Comments
    edited July 2021 #2

    It is it seems as the standard Whale inlet that any caravan accessory shop would have in stock, as they are fitted to many makes of c/van 

  • Tinwheeler
    Tinwheeler Forum Participant Posts: 23,141 ✭✭✭
    10,000 Likes 1000 Comments Name Dropper
    edited July 2021 #3

    Agreed. Toddle along to your nearest accessory shop and you can see what's on the shelf.

  • Navigateur
    Navigateur Club Member Posts: 3,880 ✭✭✭✭✭
    1000 Comments
    edited July 2021 #4

    Even the lid is available seperately.

  • John and Patricia
    John and Patricia Forum Participant Posts: 5
    edited July 2021 #5

    Thanks Guys currently in isolation so can't venture out but will look on line 

    thanks again

  • richardandros
    richardandros Club Member Posts: 2,681 ✭✭✭
    1,000 Likes 1000 Comments Name Dropper Photogenic
    edited July 2021 #6

    It's a 10 minute job to replace it once you have disconnected the push fit pipe at the other side.  You will find a non-setting mastic gasket behind the fitting which - if you're very careful in removing the socket, can be re-used.  That said, given the age of the van, it's probably best to replace it. If you can't buy a gasket off the shelf, the mastic can be bought in a roll. I bought some years ago for a job on the boat and I know that most decent yacht chandlers sell it.

  • JVB66
    JVB66 Forum Participant Posts: 22,892
    1000 Comments
    edited July 2021 #7

    Interesting comment ,as when ours was leaking due to split ,when at Seacroft , it took the mobile man nearly an hour as he said he would not use old 5yrs sealant so cleaned it all off and when fitted it needed the pressure switch resetttingsurprised 

  • John and Patricia
    John and Patricia Forum Participant Posts: 5
    edited July 2021 #8

    Don't think I will have an issue replacing it I have the gear here just needed to make sure i was going to order the right fittings really.

    I have two sided mastic white spirit methylated spirit and one sided plastic razor which I have ready to replace some of the trims as they are getting rather old and brittle.

    Although the van is 20 years old I'm absolutely made up with the condition and we have already had many lovely trips in her looking forward to Anglesey mid August one of our very favourite places.

     

    Thanks again 

    John

     

Categories