Rubber Seal

Oakley2017
Oakley2017 Forum Participant Posts: 15
edited March 2019 in Motorhomes #1

Hi All

Has anyone fitted a rubber seal  on a Heki mini roof vent if so how have you done it as no instructions came with it.

Any ideas would be appreciated.

 

Many Thanks

Comments

  • KeithandMargaret
    KeithandMargaret Forum Participant Posts: 660 Participant
    500 Comments
    edited March 2019 #2

    Is this any help ?

    https://youtu.be/ToeqlFeSd1o

     

     

  • Oakley2017
    Oakley2017 Forum Participant Posts: 15
    edited March 2019 #3

    Hi Keith & Margaret

    Thanks for your reply we have viewed the link that you sent but unfortunately it is the rubber seal on the dome that we are struggling to fit.

  • Takethedogalong
    Takethedogalong Forum Participant Trusted Posts: 17,590
    10,000 Likes 1000 Comments Name Dropper Photogenic
    edited March 2019 #4

    If it’s too unpliable, put it into warm, not boiling,  water. This might make it easier to fit. Dry it off quickly while still warm and then try fitting it.

  • Ted on tour
    Ted on tour Forum Participant Posts: 2
    edited March 2019 #5

    I did it with the roof vent in-situ ok with a flat-headed screwdriver and a lot of patience. The trick was to start the seal in the middle of a straight run, and roughly stick it in position at some key points all the way round - this prevents the weight of the trailing seal pulling out all the work you’ve done. Then run it into position properly. It’s a little longer than you need, so trim it off when finished. Didn’t use any glue, and it has stayed in position for more than a year so far. 

    Murder on the arms though!

Categories