Pairing a new remote to the Easi Move mover

jojax64
jojax64 Forum Participant Posts: 3
edited May 2016 in Caravan & Motorhome Chat #1

We are newbies to caravanning. Our van has the Easi Move Riviera, the handset remote is the UR 203.

The remote was iffy, so we bought a new one off eBay. We have no idea how to pair it to the control unit. Presently it has a flashing led when switched on.

Can anybody assist? Thanks.

Comments

  • EmilysDad
    EmilysDad Forum Participant Posts: 8,973
    1000 Comments
    edited May 2016 #2

    Google is your friend ........ 

    http://www.easi-move.com/installation-fitting

    http://www.easi-move.com/sites/default/files/Easi-Move-V4-3.pdf

    The Reset Button (Fig.3A): The remote control handset and the control unit are synchronised with each other in the factory. If the control unit or the remote control handset is replaced, they must be re-synchronised as described below:  Check the installation
    in accordance with the installation instructions and ensure that the drive rollers are not applied. Check that the battery is properly connected, check the condition of the battery and that a voltage of 12 V is present at the control unit.  Please ensure
    that the battery isolation Switch is on.  Press the reset button (Fig.3A) on the control unit and hold down. The green LED (Fig.3B) flashes slowly.  Activate the remote control handset by sliding the slide switch to “On”-I (Fig.5A). The green LED on the
    control unit (Fig.3B) starts to flash rapidly. The remote control handset and the control unit are now synchronised to each other. Finally push the reset button (Fig.3A) on the control unit again to complete the re-synchronisation.  After successful synchronisation,
    the green LED on the control unit (Fig.3B) and on the remote control handset (Fig.5H) will illuminate continuously.

  • jojax64
    jojax64 Forum Participant Posts: 3
    edited May 2016 #3

    Thanks. Already been there, though. As far as I can see there is no reset button on the remote. There is no fig. 3A in the PDF either.......kinda frustrating. Lol.

  • EmilysDad
    EmilysDad Forum Participant Posts: 8,973
    1000 Comments
    edited May 2016 #4

    Have you tried a local caravan dealer? They might know. The Reich controller for mine needed a few attempts to make it pair with my mover

  • jojax64
    jojax64 Forum Participant Posts: 3
    edited May 2016 #5

    Ah.....the reset button is on the controller, not the handset. Will have a go with it later.

Categories