Alde Heating Bailey Unicorn 3

Blueboy22
Blueboy22 Forum Participant Posts: 5
edited February 2016 in Parts & Accessories #1

Recently had a remote sensor fitted which fixed the high temp readings now the heating clicks on when at correct temp and then off again 5 seconds later it keeps doing this until I manually adjust the temp settings 

Comments

  • SteveL
    SteveL Club Member Posts: 12,311 ✭✭✭
    5,000 Likes 1000 Comments Name Dropper
    edited February 2016 #2

    It should keep clicking on and off once it has reached temperature, but not every 5 seconds. Ours is often only on for a minute or so, then off for 2 / 3 then on again. It all depends on the outside temperature and if the heating can replace heat faster
    than it is being lost. If it is on the loosing side, it stays on for longer.

  • JVB66
    JVB66 Forum Participant Posts: 22,892
    1000 Comments
    edited February 2016 #3

    It depends where you have fitted the remote sensor ,if it is in a draught or a very cold spot then it will keep activating the heating

Categories